YellowStone 3.5" Clear Laser Printed Waterslide
Single Clear Laser Printed Waterslide as pictured in listing
Approximately 3.5-4” depending on design.
These are perfect size for a tumbler.
The actual waterside will come without the watermark.
Please see the instructions below:
1. Cut out the image
2. Place it in warm water for approx. 30 Seconds
3. Wet down area on tumbler that you’d like to place the waterslide
4. Slide the waterslide onto the tumbler.
5. Take a damp paper towel and smooth out and wrinkles in the slide.
6. Let completely dry before adding epoxy.
CUSTOM SIZES CAN BE MADE -Message us separately to get a specific order size that you'd like.
THIS LISTING IS FOR THE WATERSLIDE 3.5" to 4" DEPENDING ON DESIGN ONLY
Please Note User upon purchase that it is understood that these will not be replaced due to application error. There are plenty of tutorials on how to apply a waterslide. If you are new to applying these, please refer to one of the tutorials found online to apply these.